LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Brakes >> Parking Brake System >> Park Brake >> Repair Instructions >> Parking Brake Release Handle Assembly Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Park Brake Release Lever Handle & Bolt
    GM376009Courtesy of GENERAL MOTORS CORP.
  1. Install the park brake release handle assembly to the vehicle. Install the cable using the same routing as the original cable.
  2. Install the park brake release cable to the pedal assembly.
  3. Install the park brake release cable housing to the pedal assembly.
  4. Install the MID-Bussed Electrical Center to the bracket.
  5. Install the park brake release lever handle to the knee bolster.
    6. NOTE: Refer to Fastener Notice .
  6. Install the park brake release lever mounting bolt.

    Tighten:  Tighten the bolt to 25 N.m (18 lb ft).

  7. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
scientia non olet · About LEMON Manuals