LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Brakes >> Parking Brake System >> Park Brake >> Repair Instructions >> Parking Brake Rear Cable Replacement - Left Side >> Removal Procedure

Removal Procedure

  1. Disable the park brake cable automatic adjuster. Refer to Parking Brake Cable Adjuster Disabling .
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    3. Fig 1: View Of Park Brake Cable - Front/Intermediate
    GM363830Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the left rear cable from the front cable.
    4. Fig 2: Left Rear Cable & Equalizer
    GM793184Courtesy of GENERAL MOTORS CORP.
  4. Remove the left rear cable (4) from the equalizer (1) by depressing the locking tabs.
    5. Fig 3: Left Rear Cable & Cable Support
    GM793182Courtesy of GENERAL MOTORS CORP.
  5. Remove the left rear cable (3) from the cable support (2).
    6. Fig 4: Cable, Lever & Backing Plate
    GM793127Courtesy of GENERAL MOTORS CORP.
  6. Remove the cable (3) from the backing plate (1) by compressing the spring to access and depress the locking tabs, pull the cable out of the backing plate, and routing the cable through the slot in the backing plate.
  7. Remove the cable (3) from the lever (2).
    8. Fig 5: Left Rear Park Brake Cable
    GM793186Courtesy of GENERAL MOTORS CORP.
  8. Remove the left rear cable (1) from the cable guide (2).
  9. Remove the cable from the vehicle.
scientia non olet · About LEMON Manuals