LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Brakes >> Parking Brake System >> Park Brake >> Repair Instructions >> Parking Brake Front Cable Replacement >> Removal Procedure

Removal Procedure

  1. Disable the park brake cable automatic adjuster. Refer to Parking Brake Cable Adjuster Disabling .
  2. Remove the park brake pedal. Refer to Parking Brake Lever Pedal Assembly Replacement .
    3. Fig 1: Front Park Brake Cable Grommet
    GM376010Courtesy of GENERAL MOTORS CORP.
  3. Roll the carpet back to access cable grommet.
  4. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    5. Fig 2: View Of Park Brake Cable - Front/Intermediate
    GM363830Courtesy of GENERAL MOTORS CORP.
  5. Disengage the grommet and the cable from the floor pan.
  6. Disconnect the front cable from the rear cable.
  7. Remove the cable from the body mount by depressing the retaining tabs.
  8. Remove the cable.
scientia non olet · About LEMON Manuals