LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Brakes >> Parking Brake System >> Park Brake >> Repair Instructions >> Parking Brake Front Cable Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Park Brake Cable - Front/Intermediate
    GM363830Courtesy of GENERAL MOTORS CORP.
  1. Install the cable.
  2. Snap the retainer tabs into the body mount.
  3. Connect the front cable to the rear cable.
  4. Route the cable in through the floor pan and engage the grommet.
  5. Remove the safety stands.
  6. Lower the vehicle.
    7. Fig 2: Front Park Brake Cable Grommet
    GM376010Courtesy of GENERAL MOTORS CORP.
  7. Roll the carpet into place.
  8. Install the park brake pedal. Refer to Parking Brake Lever Pedal Assembly Replacement .
  9. Enable the park brake cable automatic adjuster. Refer to Parking Brake Cable Adjuster Enabling .
scientia non olet · About LEMON Manuals