LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Brakes >> Parking Brake System >> Park Brake >> Repair Instructions >> Park Brake Backing Plate Replacement >> Installation Procedure

Installation Procedure

  1. Install the backing plate to the axle housing flange.
    2. Fig 1: View Of Backing Plate & Nuts - Rear
    GM370688Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  2. Install the backing plate nuts.

    Tighten:  Tighten the backing plate bolts to 135 N.m (100 lb ft).

  3. Install the park brake shoe. Refer to Parking Brake Shoe Replacement .
  4. Install the axle shaft. Refer to Rear Axle Shaft Replacement .
  5. Adjust the park brake shoe. Refer to Park Brake Adjustment .
  6. Install the rotor. Refer to Rear Brake Rotor Replacement .
  7. Install the park brake cable to the mounting bracket until the locking tabs snap into place.
  8. Install the rear park brake cable to the park brake actuator lever.
  9. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  10. Remove the safety stands.
  11. Lower vehicle.
  12. Enable the park brake cable automatic adjuster. Refer to Parking Brake Cable Adjuster Enabling .
scientia non olet · About LEMON Manuals