LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brakes >> Repair Instructions >> Rear Brake Hose Replacement (Jounce) >> Removal Procedure

Removal Procedure

    Fig 1: Rear (Jounce) Brake Hose Bracket Bolt
    GM793158Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Clean all dirt and foreign material from the brake hose and brake pipe fittings.
    3. IMPORTANT: Install a rubber cap or plug to the exposed brake pipe fitting ends in order to prevent brake fluid loss and contamination.
  3. Use a backup wrench on the hose fitting, disconnect the brake pipe fitting from the brake hose, then cap or plug the brake pipe fitting end.
  4. Remove the brake hose upper bracket bolt.
    5. Fig 2: Rear (Jounce) Brake Hoses
    GM793160Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Install a rubber cap or plug to the exposed brake pipe fitting ends in order to prevent brake fluid loss and contamination.
  5. Using a backup wrench on the hose fittings, disconnect the brake pipe fittings from the brake hoses (1), then cap or plug the brake pipe fitting ends.
  6. Remove the brake hose lower bracket bolt (2).
  7. Remove the jounce hoses.
scientia non olet · About LEMON Manuals