LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brakes >> Repair Instructions >> Power Brake Booster Outlet Front Pipe Replacement >> Tools Required >> Removal Procedure

Removal Procedure

    Fig 1: Identifying Brake Master Cylinder And Power Brake Booster Assembly
    GM1977780Courtesy of GENERAL MOTORS CORP.
  1. Remove the brake master cylinder and power brake booster assembly. Refer to Brake Master Cylinder with Power Brake Booster and Chassis Control Module Replacement .
  2. Install the CH-47830  (1) to the master cylinder assembly.
  3. Position the CH-47830  with the master cylinder assembly in a vise.
    4. Fig 2: Power Brake Booster Outlet Front Pipe
    GM1977959Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the brake pipe fittings and remove the power brake booster outlet front pipe (1).
scientia non olet · About LEMON Manuals