LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brakes >> Repair Instructions >> Power Brake Booster Outlet Front Pipe Replacement >> Installation Procedure

Installation Procedure

    NOTE: Refer to Fastener Notice .
    Fig 1: Power Brake Booster Outlet Front Pipe
    GM1977959Courtesy of GENERAL MOTORS CORP.
  1. Install the power brake booster outlet front pipe (1) and connect the brake pipe fittings.

    Tighten:  Tighten the fittings to 15 N.m (11 lb ft).

    2. Fig 2: Identifying Brake Master Cylinder And Power Brake Booster Assembly
    GM1977780Courtesy of GENERAL MOTORS CORP.
  2. Remove the CH-47830  (1) from the master cylinder assembly.
  3. Remove the brake master cylinder and power brake booster assembly. Refer to Brake Master Cylinder with Power Brake Booster and Chassis Control Module Replacement .
scientia non olet · About LEMON Manuals