LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brakes >> Repair Instructions >> Brake Pedal Assembly Replacement >> Removal Procedure

Removal Procedure

    Fig 1: View Of Brake Pedal Bolt & Nut
    GM375693Courtesy of GENERAL MOTORS CORP.
  1. Without disconnecting the electrical connector, remove the stop lamp switch. Refer to Stop Lamp Switch Replacement .
  2. Remove the nut from the brake pedal bolt.
  3. Remove the brake pedal bolt.
  4. Remove the brake pedal.
scientia non olet · About LEMON Manuals