LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brakes >> Repair Instructions >> Brake Pedal Assembly Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Brake Pedal Bolt & Nut
    GM375693Courtesy of GENERAL MOTORS CORP.
  1. Install the brake pedal.
  2. Install the brake pedal bolt.
    3. NOTE: Refer to Fastener Notice .
  3. Install the nut to the brake pedal bolt.

    Tighten:  Hold the nut stationary and tighten the brake pedal bolt to 47 N.m (35 lb ft).

  4. Install the stop lamp switch. Refer to Stop Lamp Switch Replacement .
scientia non olet · About LEMON Manuals