LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes >> Repair Instructions >> Rear Disc Brake Backing Plate Replacement >> Removal Procedure

Removal Procedure

  1. Disable the park brake cable automatic adjuster. Parking Brake Cable Adjuster Disabling .
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  3. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  4. Remove the rear park brake cable from the park brake actuator lever.
  5. Remove the park brake cable from the mounting bracket by depressing the locking tabs.
  6. Remove the rotor. Refer to Rear Brake Rotor Replacement .
  7. Remove the axle shaft. Refer to Rear Axle Shaft Replacement .
  8. Remove the park brake shoe. Refer to Parking Brake Shoe Replacement .
    9. Fig 1: View Of Backing Plate & Nuts - Rear
    GM370688Courtesy of GENERAL MOTORS CORP.
  9. Remove the backing plate nuts.
  10. Remove the backing plate from axle housing flange.
scientia non olet · About LEMON Manuals