LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes >> Repair Instructions >> Front Brake Shield Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Splash Shield (25/35 Series)
    GM371077Courtesy of GENERAL MOTORS CORP.
  1. Install the splash shield.
  2. Install the hub and bearing assembly. Refer to Front Wheel Hub, Bearing, and Seal Replacement .
  3. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  4. Remove the safety stands.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals