LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes >> Repair Instructions >> Front Brake Caliper Bracket Replacement >> Removal Procedure

Removal Procedure

    NOTE: Support the brake caliper with heavy mechanic wire, or equivalent, whenever it is separated from its mount and the hydraulic flexible brake hose is still connected. Failure to support the caliper in this manner will cause the flexible brake hose to bear the weight of the caliper, which may cause damage to the brake hose and in turn may cause a brake fluid leak.
  1. Remove the caliper from the mounting bracket and support the caliper with heavy mechanic's wire or equivalent. DO NOT disconnect the hydraulic brake flexible hose from the caliper. Refer to Front Brake Caliper Replacement .
    2. Fig 1: View Of Disc Brake Pads & Brake Caliper Mounting Bracket
    GM369668Courtesy of GENERAL MOTORS CORP.
  2. Remove the brake pads.
  3. Remove the anti-rattle clips from the brake caliper bracket.
    4. Fig 2: Brake Caliper Bracket Mounting & Bolts
    GM794150Courtesy of GENERAL MOTORS CORP.
  4. Remove the brake caliper bracket mounting bolts (2).
  5. Remove the brake caliper bracket (1).
  6. Remove any contaminants or foreign material from the inside ends of the brake caliper bracket.
  7. Clean the mounting surface and threads of the brake caliper bracket.
scientia non olet · About LEMON Manuals