LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Body & Frame >> Seats >> Seat Heating And Cooling >> Diagnostic Information and Procedures >> Heated Seat Inoperative >> Circuit/System Testing

Circuit/System Testing

  1. Ignition ON, verify that the driver and passenger door switch heated seat switch parameters display Active while the heated seat switches are pressed.
    • If either of the switch parameters are continuously Active or Inactive while the switch is pressed, perform the heated seat switch circuit test.
  2. Verify that the MSM driver and passenger seat HVC mode and level parameters are displayed correctly as the heated seat switches are activated through all of the operating modes.
    • If the MSM parameters are not displayed correctly replace the MSM.
  3. If the circuits test normal replace the driver or passenger door module.
scientia non olet · About LEMON Manuals