LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Body & Frame >> Seats >> Seat Heating And Cooling >> Diagnostic Information and Procedures >> DTC B2508 or B2509 (Rear Seat) >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the X1 harness connector at the heated seat module.
  2. Test for infinite resistance between the left seat heating element supply voltage circuit terminal 3 and ground.
    • If less than infinite resistance, test the supply voltage circuit and the seat cushion heating element control circuit for a short to ground.
  3. Ignition ON, verify that a test lamp does not illuminate between the supply voltage circuit terminal 3 and ground.
    • If the test lamp illuminates, test the supply voltage circuit and the seat cushion heating element control circuit for a short to voltage.
  4. Test for infinite resistance between the right seat heating element supply voltage circuit terminal 6 and ground.
    • If less than infinite resistance, test the supply voltage circuit and the seat cushion heating element control circuit for a short to ground.
  5. Ignition ON, verify that a test lamp does not illuminate between the supply voltage circuit terminal 6 and ground.
    • If the test lamp illuminates, test the supply voltage circuit and the seat cushion heating element control circuit for a short to voltage.
  6. If all circuits test normal, replace the heated seat module.
scientia non olet · About LEMON Manuals