LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Body & Frame >> Seats >> Seat Heating And Cooling >> Diagnostic Information and Procedures >> DTC B2435 or B2440 >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the MSM harness connector X5.
  2. Test for a minimum of 850 ohms of resistance from the signal circuit to ground.
    • If less than 850 ohms, test the signal circuit for a short to ground. If the circuit tests normal, replace the seat back heater element.
  3. If all circuits test normal, replace the MSM.
scientia non olet · About LEMON Manuals