LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Body & Frame >> Seats >> Seat Heating And Cooling >> Diagnostic Information and Procedures >> DTC B1925 or B2170 >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the MSM or rear heated seat module harness connector X5 for driver or front passenger seat or X4 for a rear passenger seat.
  2. Test for a minimum of 850 ohms of resistance from the signal circuit to ground.
    • If less than 850 ohms, test the signal circuit for a short to ground. If the circuit tests normal, replace the seat cushion heater element.
  3. If all circuits test normal, replace the MSM or rear heated seat module.
scientia non olet · About LEMON Manuals