LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Body & Frame >> Seats >> Seat Hardware, Trim, And Upholstery >> Repair Instructions >> Rear Seat Back Latch Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Latch Assembly Spacer & Seat Belt Guide
    GM814964Courtesy of GENERAL MOTORS CORP.
  1. Install the seat belt guide (1) to the latch assembly, if removed.
  2. Install the spacer (2) to the latch assembly, if removed.
    3. Fig 2: View Of Latch Assembly Bolts & Screws
    GM788614Courtesy of GENERAL MOTORS CORP.
  3. Install the seat back latch assembly to the seat frame.
  4. Attach the recliner cables to the folding mechanism.
    5. NOTE: Refer to FASTENERS .
  5. Install the bolts (1, 2) that retain the latch assembly to the seat frame.

    Tighten:  Tighten the bolts to 45 N.m (33 lb ft).

  6. Install the screw (3) that retains the latch assembly to the seat frame.

    Tighten:  Tighten the screw to 25 N.m (18 lb ft).

  7. Install the seat back cover. Refer to Rear Seat Back Cushion Cover and Pad Replacement .
  8. Install the armrest, if equipped. Refer to Rear Seat Armrest Replacement .
  9. Install the rear seat to the vehicle. Refer to Rear Seat Replacement .
scientia non olet · About LEMON Manuals