LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Body & Frame >> Seats >> Seat Hardware, Trim, And Upholstery >> Repair Instructions >> Rear Seat Back Cushion Frame Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Seat Back Frame Components
    GM276335Courtesy of GENERAL MOTORS CORP.
  1. Install the seat-back frame (4) to the seat cushion frame.
    2. NOTE: Refer to Fastener Notice .
  2. Install the bolts which retain the seat-back frame to the seat cushion frame.

    Tighten:  Tighten the bolts to 35 N.m (26 lb ft).

  3. Install the seat-back cover. Refer to Rear Seat Back Cushion Cover and Pad Replacement .
  4. Install the armrest to the seat back. Refer to Rear Seat Armrest Replacement .
  5. Install the seat to the vehicle. Refer to Rear Seat Replacement .
scientia non olet · About LEMON Manuals