LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Body & Frame >> Seats >> Seat Hardware, Trim, And Upholstery >> Repair Instructions >> Rear Seat Armrest Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Rear Seat Armrest (60/40 Split)
    GM820686Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the center armrest to the seat frame.
  2. Install the bolts to the center armrest.

    Tighten:  Tighten the bolt to 9 N.m (80 lb in).

scientia non olet · About LEMON Manuals