LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Body & Frame >> Seats >> Power Seats >> Diagnostic Information and Procedures >> DTC B1735, B1740, B1745, B1750, B1755, B1760, B1815, or B1820 >> Component Testing

Component Testing

  1. Ignition OFF, disconnect the harness connector at the seat adjuster switch.
  2. Test for infinite resistance between each seat direction signal terminal and the switch B+ terminal with the switch in the open position.
    • If less than infinite resistance, replace the switch.
  3. Test for less than 1 ohm of resistance between each seat direction signal terminal and the B+ terminal with the switch in the closed position.
    • If greater than 1 ohm, replace the switch.
scientia non olet · About LEMON Manuals