LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Body & Frame >> Frames, Subframes & Crossmembers >> Frame And Underbody >> Repair Instructions >> Trailer Hitch Replacement (SUT) >> Installation Procedure

Installation Procedure

    Fig 1: Trailer Hitch
    GM796194Courtesy of GENERAL MOTORS CORP.
  1. Position the trailer hitch to the rear frame rail.
    2. NOTE: Refer to Fastener Notice .
  2. Install the 2 forward bolts.

    Tighten:  Tighten the bolts to 85 N.m (63 lb ft).

    3. Fig 2: Air Suspension Compressor Bracket
    GM1467102Courtesy of GENERAL MOTORS CORP.
  3. Install the 2 bolts (1) to the rear edge of the air suspension compressor bracket (2).

    Tighten:  Tighten the bolts to 85 N.m (63 lb ft).

  4. Secure the electrical harness conduit to the inner surface of the trailer hitch.
  5. Install the rear bumper. Refer to Rear Bumper Replacement (SUT) or Rear Bumper Replacement (SUV) .
scientia non olet · About LEMON Manuals