Removal Procedure

Support the frame with the hoist when you change the body mounts. If only one mount is changed loosen and lower the entire side on which the mount in question is being replaced.

1. Raise the vehicle on a hoist. Refer to Lifting and Jacking the Vehicle .
2. Using jack stands or the equivalent to support the body where the mounts will be replaced.
Fig 1: Body Mount Bolt, Retainer & Lower Cushion At Radiator Support
Courtesy of GENERAL MOTORS CORP.
3. Remove the body mount bolt, retainer, and lower cushion at the radiator support.
Fig 2: Body Mount Bolt, Retainers & Lower Cushions At Front Mount
Courtesy of GENERAL MOTORS CORP.
4. Remove the body mount bolt, retainers, and lower cushions at the front mount location.
Fig 3: Body Mount Bolt, Retainers & Lower Cushions At Other Mounts
Courtesy of GENERAL MOTORS CORP.
5. Remove the body mount bolt, retainers, and lower cushions at the three other mount locations.
Fig 4: Body Mount Bolt, Retainers & Lower Cushion At Rear Most Mount
Courtesy of GENERAL MOTORS CORP.
6. Remove the body mount bolt, retainers, and lower cushion at the rear most mount.
7. Disconnect or remove any wiring harness or component that may interfere with the lowering of the frame.
8. Lower the hoist in order to leave the body supported by the jack stands.
9. Remove the upper cushions and the shims from the vehicle.