Installation Procedure

Install the upper cushions and the shims to the vehicle.
Raise the hoist to allow the body mount bolts to be installed.
Connect or install any wiring harness or component that was removed to allow for the lowering of the frame.

Fig 1: Body Mount Bolt, Retainers & Lower Cushion At Rear Most Mount

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the body mount bolt, retainer, and lower cushion at the rear most mount.

Fig 2: Body Mount Bolt, Retainers & Lower Cushions At Other Mounts

Courtesy of GENERAL MOTORS CORP.

Install the body mount bolt, retainers, and lower cushions at the three other mount locations.

Fig 3: Body Mount Bolt, Retainers & Lower Cushions At Front Mount

Courtesy of GENERAL MOTORS CORP.

Remove the body mount bolt, retainers, and lower cushions at the front mount location.

Fig 4: Body Mount Bolt, Retainer & Lower Cushion At Radiator Support

Courtesy of GENERAL MOTORS CORP.

Install the body mount bolt, retainer, and lower cushion at the radiator support.
Tighten: Tighten the bolts to 85 N.m (63 lb ft).
Remove the jack stands.
Lower the vehicle.