Installation Procedure

Perform the following procedure before installing the bolts.
- Remove all traces of the original adhesive patch.
- Clean the threads of the bolt with denatured alcohol or equivalent and allow to dry.
- Apply Threadlocker GM P/N 12345382 (Canadian P/N 10953489).

IMPORTANT: Using a level, secure the fasteners for the 2 inner brackets first. The assist step should be held level in relationship to the vehicle. Secure the fasteners for the outer brackets after the inner fasteners have been torqued.

Fig 1: Assist Step (Tubular BVE)

Courtesy of GENERAL MOTORS CORP.

Install the assist step to the vehicle. An assistant may be necessary for this step.

NOTE: Refer to Fastener Notice .

Install the nuts and the bolts.
Tighten: Tighten the nuts to 50 N.m (39 lb ft).