LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Body & Frame >> Fixed And MOVEABLE Windows >> Repair Instructions >> Rear Side Door Window Channel Replacement >> Installation Procedure

Installation Procedure

  1. With the window in the full up position, position the run channel (2) in place inside the door.
    2. NOTE: Refer to Fastener Notice .
  2. Install the fasteners (1) retaining the run channel to the door.

    Tighten:  Tighten the fasteners to 9 N.m (6 lb ft).

    3. Fig 1: Rear Door Window Run Channel
    GM839203Courtesy of GENERAL MOTORS CORP.
  3. Install the water deflector. Refer to Rear Side Door Water Deflector Replacement .
  4. Install the door trim panel. Refer to Front Side Door Trim Panel Replacement .
scientia non olet · About LEMON Manuals