LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Interior Trim And Paneling >> Repair Instructions >> Liftgate Trim Panel Replacement (SUV) >> Removal Procedure

Removal Procedure

    Fig 1: Cargo Tie Down
    GM833484Courtesy of GENERAL MOTORS CORP.
  1. Remove the lift gate pullstrap. Refer to Liftgate Pull Strap Replacement (SUV) .
  2. Remove the bolt that retains the cargo tie down.
    3. Fig 2: Liftgate Trim Panel
    GM833482Courtesy of GENERAL MOTORS CORP.
  3. Remove the 2 push pin fasteners at the bottom edge of the liftgate trim panel
  4. Gently pull on the lift gate trim panel to disengage the retaining clips.
  5. Remove the lift gate trim panel from the vehicle.
  6. Inspect for broken or missing retaining clips and replace the clips as necessary.
scientia non olet · About LEMON Manuals