LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Exterior Trim >> Repair Instructions >> Windshield Side Reveal Molding Replacement (Side) >> Removal Procedure

Removal Procedure

    Fig 1: Windshield Pillar Side Reveal Molding
    GM826350Courtesy of GENERAL MOTORS CORP.
  1. Remove the air inlet grille panel. Refer to Non-Functional Air Inlet Grille Panel Replacement .
  2. Remove the retaining screws.
  3. Apply outward pressure at the bottom of the windshield pillar reveal molding to release the adhesive strip.
  4. Pull the molding down to disengage the windshield pillar reveal molding from the roof rack.
  5. Remove the side reveal molding from the pillar
scientia non olet · About LEMON Manuals