Removal Procedure

Fig 1: Sail Panel

GM1412537

Courtesy of GENERAL MOTORS CORP.

Remove both the LH and RH sail panels. Refer to Sail Panel Molding Replacement (Left Side) .

Fig 2: Removing/Installing CHMSL Assembly

GM1477816

Courtesy of GENERAL MOTORS CORP.

Remove the two screws securing the center high mounted stop lamp (CHMSL) to the rear header garnish molding.

Fig 3: Rear Header Garnish Molding

GM1412534

Courtesy of GENERAL MOTORS CORP.

Remove the screws (1) securing the rear header garnish molding (2) to the rear roof header.
Release the adhesive tape from the top edge of the header garnish molding.
Release the retainers from the bottom edge of the garnish molding.
Remove the roof rear header garnish molding from the vehicle as the CHMSL is guided through the garnish molding opening.
Clean any leftover adhesive with a 50/50 mixture of isopropyl alcohol and clean drinkable water.