LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Exterior Trim >> Repair Instructions >> Rear Wheel Opening Flare Replacement (WS2, BVX) >> Removal Procedure

Removal Procedure

    Fig 1: Rear Wheel Opening Flare (SUV)
    GM826367Courtesy of GENERAL MOTORS CORP.
  1. Remove the retaining screws from the wheel flare.
  2. Remove the push-pin retainer from the rocker protection molding.
  3. Remove the wheel flare from the vehicle.
  4. Use a alcohol pad in order to remove old adhesive tape residue from the fender flange.
  5. Wipe the area where the flare is to be installed with a clean dry towel prior to the wheel opening flare installation.
scientia non olet · About LEMON Manuals