LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Exterior Trim >> Repair Instructions >> Rear License Plate Pocket Replacement (SUV) >> Removal Procedure

Removal Procedure

  1. Open the liftgate.
  2. Remove the liftgate trim panel. Refer to Liftgate Trim Panel Replacement (SUV) .
    3. Fig 1: Latch Cable Handle Connection
    GM832874Courtesy of GENERAL MOTORS CORP.
  3. Remove the latch cable handle connection by releasing the retainer (1) and removing the cable end from the handle arm.
    4. Fig 2: License Plate Pocket Electrical Connectors (SUV)
    GM880649Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the 2 license plate pocket electrical connectors (3).
    5. Fig 3: License Plate Pocket Nuts (SUV)
    GM1453816Courtesy of GENERAL MOTORS CORP.
  5. Remove the 6 nuts (5) retaining the plate pocket to the liftgate.
  6. Release the 4 clips (3) retaining the license plate pocket to the liftgate (2).
    7. Fig 4: License Plate Pocket & Liftgate (SUV)
    GM1453815Courtesy of GENERAL MOTORS CORP.
  7. Remove the license plate pocket (2) from the liftgate (3).
scientia non olet · About LEMON Manuals