LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Exterior Trim >> Repair Instructions >> Endgate Upper Molding Replacement >> Removal Procedure

Removal Procedure

    Fig 1: View Of Endgate Cap
    GM1412525Courtesy of GENERAL MOTORS CORP.
  1. Heat the inside of the endgate cap using a heat gun. Hold the heat gun approximately 152 mm (6 in) from the surface. Apply heat using a circular motion for approximately 30 seconds.
    2. IMPORTANT: Be careful not to scratch or chip the paint.
  2. Peel the endgate cap from the inner surface of the endgate using a flat-bladed tool.
  3. Remove the endgate cap.
  4. Remove all adhesive from the endgate and endgate cap using a 3M Scotch Brite molding adhesive remover disk 3M P/N 0751 or equivalent.
  5. Clean the endgate using Varnish Makers and Painters (VMP) naptha.
scientia non olet · About LEMON Manuals