LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Exterior Trim >> Repair Instructions >> Endgate Emblem/Nameplate Replacement >> Removal Procedure

Removal Procedure

    IMPORTANT: Use the tape for protection and alignment marks for alignment of the new emblem.
  1. Apply tape to the area around the endgate emblem.
  2. Heat the emblem/nameplate, using a heat gun J 25070  152 mm (6.0 in) from the surface.
  3. Apply the heat using a circular motion for about 30 seconds.
    4. NOTE: Use a plastic, flat-bladed tool to prevent paint damage when removing an emblem/name plate.
  4. Remove the emblem/nameplate from the endgate surface using a flat-bladed plastic tool.
    5. Fig 1: Locating H2 Emblem
    GM1427849Courtesy of GENERAL MOTORS CORP.
  5. Remove all adhesive from the endgate panel surface and the back of the emblem/nameplate using 3M™ scotch brite molding adhesive remover disk 3M™ P/N 07501 or equivalent.
  6. Clean the endgate surface using varnish makers and painters (VMP) naptha.
scientia non olet · About LEMON Manuals