LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bumpers And Fascias >> Repair Instructions >> Rear Bumper Replacement (SUV) >> Installation Procedure

Installation Procedure

  1. Position the rear bumper to the chassis frame.
    2. NOTE: Refer to Fastener Notice .
  2. Install the 2 rear bumper bolts.

    Tighten:  Tighten the bolts to 32 N.m (24 lb ft) at the spare tire carrier mounts.

  3. Install the rear tow eye/D-rings. Refer to Rear Tow Eye Replacement (SUT) or Rear Tow Eye Replacement (SUV) .
    4. Fig 1: Reinforcement Bar & Related Hardware
    GM1453817Courtesy of GENERAL MOTORS CORP.
  4. Install the reinforcement bar (2) to the chassis hitch bolt and end cap.
  5. Install the nuts (1, 3) and adjust the bumper height.

    Tighten:  Tighten the nuts to 32 N.m (24 lb ft).

  6. Install the push-in retainers in order to secure the bumper end caps.
    7. Fig 2: Electrical Connector For Trailer Tow Receptacle
    GM1453814Courtesy of GENERAL MOTORS CORP.
  7. Install the trailer tow receptacle (2) to the rear bumper (1).
  8. Install the bolts (3).

    Tighten:  Tighten the bolts to 9 N.m (80 lb in).

  9. Lower the vehicle. Refer to Lifting and Jacking the Vehicle .
scientia non olet · About LEMON Manuals