LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bumpers And Fascias >> Repair Instructions >> Front Bumper Impact Bar Bracket Replacement >> Removal Procedure

Removal Procedure

CAUTION: Refer to Approved Equipment for Collision Repair Caution .
  1. Disable the SIR system. Refer to SIR Disabling and Enabling .
  2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  3. Remove all related panels and components.
  4. Repair as much of the damage as possible to factory specifications.
    5. Fig 1: Tow Hook Bolts
    GM857169Courtesy of GENERAL MOTORS CORP.
  5. Remove the tow hook. Refer to Tow Hook Replacement .
  6. Note the location and remove the sealers and anti-corrosion materials from the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair .
    7. Fig 2: Locating & Removing Factory Welds
    GM855415Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not damage the frame when removing factor welds.
  7. Locate and remove the factory welds. Note the number, size and location of the welds for installation of the service bumper bracket.
    8. Fig 3: Removing Damaged Front Bumper Bracket
    GM855417Courtesy of GENERAL MOTORS CORP.
  8. Remove the damaged bumper bracket.
scientia non olet · About LEMON Manuals