LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bumpers And Fascias >> Repair Instructions >> Front Bumper End Cap Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Front Bumper End Cap
    GM851571Courtesy of GENERAL MOTORS CORP.
  1. Install the end cap to the vehicle.
    2. NOTE: Refer to Fastener Notice .
  2. Install the bolts to the end cap.

    Tighten:  Tighten the bolts to 8 N.m (71 lb in).

scientia non olet · About LEMON Manuals