LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bolted Exterior Body Panels And Closures >> Repair Instructions >> Midgate Inner Panel Replacement >> Removal Procedure

Removal Procedure

    Fig 1: Locating Push Pins On Midgate Trim Panel
    GM1486636Courtesy of GENERAL MOTORS CORP.
  1. Position the front seats fully forward.
  2. Fold the rear seat cushions forward.
  3. Lower the rear seatbacks to the floor.
  4. Remove the push pins (2) from the bottom of the midgate trim panel (1).
  5. Pull the inner midgate panel (1) towards the front of the vehicle to release the remaining panel clips.
    6. Fig 2: Midgate Inner Panel
    GM1412513Courtesy of GENERAL MOTORS CORP.
  6. Disconnect the electrical connectors from the midgate latch release switches.
  7. Remove the midgate inner panel from the midgate.
  8. Remove the midgate switches from the inner panel and transfer.
scientia non olet · About LEMON Manuals