LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bolted Exterior Body Panels And Closures >> Repair Instructions >> Midgate Inner Panel Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Midgate Latch Switches
    GM1412510Courtesy of GENERAL MOTORS CORP.
  1. Install both midgate latch switches to the midgate inner trim panel.
    2. Fig 2: Midgate Inner Panel
    GM1412513Courtesy of GENERAL MOTORS CORP.
  2. Position the midgate inner panel to the midgate structure.
  3. Connect both midgate switch electrical connectors.
  4. Align the inner panel tabs to the midgate structure.
    5. Fig 3: Locating Push Pins On Midgate Trim Panel
    GM1486636Courtesy of GENERAL MOTORS CORP.
  5. Once aligned, begin at one end of the panel (1) and gently push inward on the midgate inner trim panel (1) to secure the upper attachment clips.
  6. Install the push pins (2) along the bottom of the midgate inner trim panel (1).
  7. Raise the seatbacks into position.
  8. Restore the rear seat cushions to the upright position.
  9. Adjust both front seats back to the original position.
scientia non olet · About LEMON Manuals