LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bolted Exterior Body Panels And Closures >> Repair Instructions >> Hood Support Cable Replacement >> Removal Procedure

Removal Procedure

  1. Open the hood.
    CAUTION: Refer to Hood Hold-Open Device Caution .
    2. Fig 1: Hood Support Cable Pins
    GM822819Courtesy of GENERAL MOTORS CORP.
  2. Remove the pin retaining the lower section of the cable to the hood by removing the retaining clip (1).
    3. Fig 2: Hood Retaining Clip
    GM861772Courtesy of GENERAL MOTORS CORP.
  3. Remove the pin retaining the upper section of the cable to the hood by removing the retaining clip (1).
  4. Remove the cable from the vehicle.
scientia non olet · About LEMON Manuals