LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bolted Exterior Body Panels And Closures >> Repair Instructions >> Hood Secondary Latch Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Hood Latch Receiver
    GM859398Courtesy of GENERAL MOTORS CORP.
  1. Align the hood latch receiver (2) to the fender extension.
    2. NOTE: Refer to Fastener Notice .
  2. Install the fasteners (1) that retain the hood latch receiver (2) to the fender extension.

    Tighten:  Tighten the fasteners to 9 N.m (7 lb ft).

scientia non olet · About LEMON Manuals