LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bolted Exterior Body Panels And Closures >> Repair Instructions >> Hood Handle Replacement >> Installation Procedure

Installation Procedure

  1. Align the hood handle to the hood.
    NOTE: Refer to Fastener Notice .
    2. Fig 1: Hood Handle
    GM856695Courtesy of GENERAL MOTORS CORP.
  2. Install the fasteners (1) retaining the hood handle to the hood.

    Tighten:  Tighten the fasteners to 9 N.m (7 lb ft).

  3. Install the hood insulator. Refer to Hood Insulator Replacement .
  4. Close the hood.
scientia non olet · About LEMON Manuals