LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bolted Exterior Body Panels And Closures >> Repair Instructions >> Fuel Tank Filler Pipe Housing Replacement (ND1) >> Installation Procedure

Installation Procedure

    Fig 1: Fuel Filler Cap
    GM1486509Courtesy of GENERAL MOTORS CORP.
  1. Position the fuel pocket to the fuel fill neck.
    2. NOTE: Refer to Fastener Notice .
  2. Install the 3 screws.

    Tighten:  Tighten the screws to 6 N.m (53 lb in).

  3. Install the fuel filler cap (1).
  4. Close the fuel filler door.
scientia non olet · About LEMON Manuals