LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bolted Exterior Body Panels And Closures >> Repair Instructions >> Fuel Tank Filler Pipe Housing Replacement (BASE) >> Installation Procedure

Installation Procedure

  1. Position the filler pocket to the body quarter panel opening.
    2. Fig 1: Fuel Pocket
    GM1453824Courtesy of GENERAL MOTORS CORP.
  2. Rotate the pocket (1) 1/8 turn clockwise in order to secure to the body quarter panel.
    3. Fig 2: Fillerneck Components
    GM1453825Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  3. Install the screws (1) into the pocket (2) in order to secure the pocket to the filler neck (3).

    Tighten:  Tighten the screws to 6 N.m (53 lb in).

    4. Fig 3: View Of Fuel Pocket Components
    GM1453823Courtesy of GENERAL MOTORS CORP.
  4. Attach the fuel cap tether (3) to the fuel fill pocket (4).
  5. Secure the fuel fill cap (2) to the fuel fill neck (1).
scientia non olet · About LEMON Manuals