LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Vehicle Access >> Repair Instructions >> Endgate Lock Striker Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Striker Bolt
    GM1486514Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the striker bolt.

    Tighten:  Tighten the striker bolt to 25 N.m (18 lb ft).

  2. Close the endgate and verify the latch operation and reopen.
  3. Close the endgate.
  4. Latch and secure the spare tire carrier.
scientia non olet · About LEMON Manuals