LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Vehicle Access >> Repair Instructions >> Endgate Latch Replacement - Left Side Upper >> Installation Procedure

Installation Procedure

  1. Position the latch to the endgate.
    2. Fig 1: Latch Mechanism
    GM1428254Courtesy of GENERAL MOTORS CORP.
  2. Connect the lock rod (4) to the latch and secure the lock rod clip (3).
    3. NOTE: Refer to Fastener Notice .
  3. Push the latch inward and install the bolts. Note the cable bolt is shouldered.

    Tighten:  Tighten the latch bolts to 25 N.m (18 lb ft).

    4. Fig 2: Endgate Lock Rod Clip
    GM1412523Courtesy of GENERAL MOTORS CORP.
  4. Lift the endgate and secure the lock rod to the endgate handle.
  5. Secure the retainer clips (1).
  6. Secure the endgate cable to the endgate body bolt.
  7. Verify the operation.
  8. Close the endgate.
    9. Fig 3: Endgate Trim Bezel
    GM1412524Courtesy of GENERAL MOTORS CORP.
  9. Secure the handle bezel.
  10. Latch and secure the spare tire carrier.
scientia non olet · About LEMON Manuals