LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Accessories & Equipment >> Wiper/Washer Systems >> Wipers And Washers >> Repair Instructions >> Windshield Wiper Transmission Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Wiper Transmission Bolts & Electrical Connector
    GM837474Courtesy of GENERAL MOTORS CORP.
  1. Align the wiper transmission to vehicle.
    2. NOTE: Refer to Fastener Notice .
  2. Install the bolts (1) retaining the wiper transmission to the vehicle.

    Tighten:  Tighten the bolts to 9 N.m (7 lb ft).

  3. Connect the wiper motor electrical connector (2).
  4. Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement .
  5. Engage wipers and check for proper operation.
scientia non olet · About LEMON Manuals