LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Accessories & Equipment >> Wiper/Washer Systems >> Wipers And Washers >> Repair Instructions >> Windshield Washer Solvent Container Replacement >> Removal Procedure

Removal Procedure

  1. Remove the washer solvent and place in a suitable container.
  2. Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
    3. Fig 1: Solvent Container Nuts
    GM833989Courtesy of GENERAL MOTORS CORP.
  3. Remove the nuts (1) retaining the solvent container to the vehicle.
    4. Fig 2: Front End Inner Side Panel Gusset
    GM833961Courtesy of GENERAL MOTORS CORP.
  4. Remove the front end inner side panel gusset (2) by removing the fasteners (1).
  5. Remove the washer hoses from the "T" connections at washer pump and unseat them from the grooves in the washer bottle.
  6. Disconnect the washer pump electrical connector.
  7. Disconnect the washer level sensor electrical connector.
  8. Remove the washer reservoir from the vehicle.
scientia non olet · About LEMON Manuals