LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Accessories & Equipment >> Wiper/Washer Systems >> Wipers And Washers >> Repair Instructions >> Rear Window Wiper Motor Replacement >> Removal Procedures

Removal Procedures

    IMPORTANT: Cycle the wiper one time to ensure it is in the parked position.
  1. Remove the rear wiper arm. Refer to Rear Window Wiper Arm Replacement .
    2. Fig 1: Rear Wiper Arm Nut & Weatherseal
    GM893157Courtesy of GENERAL MOTORS CORP.
  2. Remove beauty cover (2) by twisting counterclockwise.
  3. Remove the rear wiper arm nut (3) and the weatherseal (4).
  4. Open the liftgate.
  5. Remove the liftgate trim panel. Refer to Liftgate Trim Panel Replacement (SUV) .
    6. Fig 2: Rear Wiper Motor
    GM1453829Courtesy of GENERAL MOTORS CORP.
  6. Disconnect the rear wiper motor electrical connectors from the liftgate (4).
  7. Remove the rear wiper control module.
  8. Remove the fasteners (1) retaining the wiper motor to the liftgate (2).
  9. Remove the rear wiper motor from the liftgate.
scientia non olet · About LEMON Manuals