LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Accessories & Equipment >> Wiper/Washer Systems >> Wipers And Washers >> Repair Instructions >> Rear Window Wiper Arm Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Rear Wiper Arm
    GM892509Courtesy of GENERAL MOTORS CORP.
  1. Align the wiper arm to the vehicle by aligning the tip of the wiper to the locating mark (1) on the window.
    2. NOTE: Refer to Fastener Notice .
  2. Install the nut retaining the wiper arm to the wiper motor.

    Tighten:  Tighten the nut to 17 N.m (12.5 lb ft).

  3. Swivel the wiper arm cover (2) closed.
  4. Connect the washer hose (4).
  5. Inspect the rear wiper for proper operation.
scientia non olet · About LEMON Manuals