LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Accessories & Equipment >> Interior/Illumination Lights >> Lighting >> Repair Instructions >> Tail/Turn Signal Lamp Replacement (SUT) >> Removal Procedure

Removal Procedure

  1. Open the spare tire carrier.
  2. Open the endgate.
    3. Fig 1: Endgate Support Cable
    GM1486510Courtesy of GENERAL MOTORS CORP.
  3. Release either the right or left side endgate cable from the body side bolt in order to remove the lamp.
  4. Remove the screws (2) from the lamp (1).
  5. Remove the inboard side of the lamp from the endgate opening.
  6. Pull the lamp housing outward.
  7. Disconnect the electrical harness at the main body harness connector.
    8. Fig 2: LR Lamp Assembly
    GM1453830Courtesy of GENERAL MOTORS CORP.
  8. Turn the bulb socket (3) counterclockwise one at a time from the lamp (1).
  9. Remove the bulbs from the sockets, if needed.
scientia non olet · About LEMON Manuals